The ISO3080 and ISO3086 devices are isolated full-duplex differential line drivers and receivers while the ISO3082 and ISO3088 devices are isolated half-duplex differential line transceivers for TIA/EIA 485/422 applications.

These devices are ideal for long transmission lines because the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 V_RMS of isolation for 60 s per UL 1577 between the bus-line transceiver and the logic-level interface.

Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or nearby sensitive circuitry if they are of sufficient magnitude and duration. These isolated devices can significantly increase protection and reduce the risk of damage to expensive control circuits.

The ISO3080, ISO3082, ISO3086, and ISO3088 device are qualified for use from –40°C to +85°C.

• Meets or Exceeds TIA/EIA RS-485 Requirements
• Signaling Rates up to 20 Mbps
• 1/8 Unit Load – Up to 256 Nodes on a Bus
• Thermal Shutdown Protection
• Low Bus Capacitance – 16 pF (Typical)
• 50 kV/μs Typical Transient Immunity
• Fail-safe Receiver for Bus Open, Short, Idle
• 3.3-V Inputs are 5-V Tolerant
• Bus-Pin ESD Protection
  • 12-kV HBM Between Bus Pins and GND2
  • 6-kV HBM Between Bus Pins and GND1
• Safety-Related Certifications:
  • 4000-VPK Basic Insulation, 560 VPK VIORM per DIN V VDE V 0884-10 (VDE V 0884-10): 2006-12 and DIN EN 61010-1
  • 2500 VRMS Isolation per UL 1577
  • 4000 VPK Isolation per CSA Component Acceptance Notice 5A and IEC 60950-1

• Duplex
• Full
• Data rate (Max) (Mbps)
• 20
• Isolation rating (Vrms)
• 2500
• Integrated isolated power
• No
• Operating temperature range (C)
• -40 to 85
• Fail safe
• Idle, Open, Short
• HBM ESD (kV)
• 12
• Surge voltage capability (Vpk)
• 4000

ISO3086的完整型号有：ISO3086DW、ISO3086DWR，以下是这些产品的关键参数及官网采购报价：

ISO3086DW，工作温度：-40 to 85，封装：SOIC (DW)-16，包装数量MPQ：40个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网ISO3086DW的批量USD价格：3.366（1000+）

ISO3086DWR，工作温度：-40 to 85，封装：SOIC (DW)-16，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网ISO3086DWR的批量USD价格：2.805（1000+）

ISO485EVM — ISO485EVM 评估模块

ISO485 评估模块 (EVM) 支持对 RS-485 数字隔离器的参数评估。EVM 将与出厂时安装在电路板上的 ISO3082DW 一起提供。此 EVM 专门用于与 ISO15、ISO35 (SLOS580) 和 ISO3080、ISO3082、ISO3086 或 ISO3088 (SLOS581) 配合使用。如果需要其它器件，请从 www.ti.com.cn 订购样片。如果您无法拆卸和安装器件，并且希望出厂时安装其它器件，请通过此页链接联系技术支持。请注意，此 EVM 不适用于电磁兼容性 (EMC) 测试。