The LM20143 devices are full featured PowerWise™ adjustable frequency synchronous buck regulators capable of delivering up to 3 A of continuous output current. The current mode control loop can be compensated to be stable with virtually any type of output capacitor. For most cases, compensating the device only requires two external components, providing maximum flexibility and ease of use. The device is optimized to work over the input voltage range of 2.95 V to 5.5 V, making it suited for a wide variety of low voltage systems.

The device features internal over voltage protection (OVP) and over current protection (OCP) circuits for increased system reliability. A precision enable pin and integrated UVLO allows the turn-on of the device to be tightly controlled and sequenced. Start-up inrush currents are limited by both an internally fixed and externally adjustable Soft-Start circuit. Fault detection and supply sequencing is possible with the integrated power good circuit.

The frequency of this device can be adjusted from 500 kHz to 1.5 MHz by connecting an external resistor from the RT pin to ground.

The LM20143 is designed to work well in multi-rail power supply architectures. The output voltage of the device can be configured to track a higher voltage rail using the SS/TRK pin. If the output of the LM20143 is pre-biased at startup it will not sink current to pull the output low until the internal soft-start ramp exceeds the voltage at the feedback pin.

• Available in AEC-Q100 Temperature Grade 1
• Input Voltage Range: 2.95 V to 5.50 V
• Accurate Current Limit Minimizes Inductor Size
• 97% Peak Efficiency
• Adjustable Output Voltage Down to 0.80 V
• Adjustable Switching Frequency (500 kHz to 1.5 MHz)
• 32-mΩ Integrated FET Switches
• Starts into Prebiased Loads
• Output Voltage Tracking
• Peak Current Mode Control
• Adjustable Soft-Start with External Capacitor
• Precision Enable Pin with Hysteresis
• Integrated OVP, UVLO, Power Good and Thermal Shutdown

• Vin (Min) (V)
• 2.95
• Vin (Max) (V)
• 5.5
• Vout (Min) (V)
• 0.8
• Vout (Max) (V)
• 5
• Iout (Max) (A)
• 3
• Iq (Typ) (uA)
• 3500
• Switching frequency (Min) (kHz)
• 510
• Switching frequency (Max) (kHz)
• 1500
• Features
• Enable, Power Good, Pre-Bias Start-Up, Synchronous Rectification, Tracking
• Rating
• Automotive
• Regulated outputs (#)
• 1
• Control mode
• Current Mode
• Duty cycle (Max) (%)
• 85

LM20143-Q1的完整型号有：LM20143QMH/NOPB、LM20143QMHE/NOPB、LM20143QMHX/NOPB，以下是这些产品的关键参数及官网采购报价：

LM20143QMH/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-16，包装数量MPQ：92个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：SN，TI官网LM20143QMH/NOPB的批量USD价格：1.67（1000+）

LM20143QMHE/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-16，包装数量MPQ：250个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：SN，TI官网LM20143QMHE/NOPB的批量USD价格：1.67（1000+）

LM20143QMHX/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-16，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：SN，TI官网LM20143QMHX/NOPB的批量USD价格：1.428（1000+）

LM20143EVAL — 3A，PowerWise®：调节频率同步降压稳压器评估模块

The LM20143 is a full featured buck switching regulator capable of driving up to 3A of load current. The switching frequency of the LM20143 can be varied from 500kHz to 1.5Mhz with an external resistor allowing the size of the power stage components to be reduced while still providing efficient (...)

LM20143 Unencrypted PSpice Transient Model

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)