The LM2745/8 are high-speed synchronous buck regulator controllers with an accurate feedback voltage accuracy of ±1.5%. It can provide simple down conversion to output voltages as low as 0.6V. Though the control sections of the IC are rated for 3 to 6V, the driver sections are designed to accept input supply rails as high as 14V. The use of adaptive non-overlapping MOSFET gate drivers helps avoid potential shoot-through problems while maintaining high efficiency. The IC is designed for the more cost-effective option of driving only N-channel MOSFETs in both the high-side and low-side positions. It senses the low-side switch voltage drop for providing a simple, adjustable current limit.

The LM2745/8 features a fixed-frequency voltage-mode PWM control architecture which is adjustable from 50 kHz to 1 MHz with one external resistor. In addition, the LM2745 also allows the switching frequency to be synchronized to an external clock signal over the range of 250 kHz to 1 MHz. This wide range of switching frequency gives the power supply designer the flexibility to make better tradeoffs between component size, cost and efficiency.

Features include the ability to startup with a pre-biased load on the output, soft-start, input undervoltage lockout (UVLO) and Power Good (based on both undervoltage and overvoltage detection). In addition, the shutdown pin of the IC can be used for providing startup delay, and the soft-start pin can be used for implementing precise tracking, for the purpose of sequencing with respect to an external rail.

• Switching Frequency from 50 kHz to 1 MHz
• Switching Frequency Synchronize Range 250 kHz to 1 MHz (LM2745 Only)
• Startup with a Pre-biased Output Load
• Power Stage Input Voltage from 1V to 14V
• Control Stage Input Voltage from 3V to 6V
• Output Voltage Adjustable Down to 0.6V
• Power Good Flag and Shutdown
• Output Overvoltage and Undervoltage Detection
• ±1.5% Feedback Voltage Accuracy Over Temperature
• Low-side Adjustable Current Sensing
• Adjustable Soft-start
• Tracking and Sequencing with Shutdown and Soft Start Pins
• TSSOP-14 Package

All trademarks are the property of their respective owners.

• Vin (Min) (V)
• 1
• Vin (Max) (V)
• 14
• Vout (Min) (V)
• 0.6
• Vout (Max) (V)
• 12
• Iout (Max) (A)
• 20
• Iq (Typ) (uA)
• 1700
• Switching frequency (Min) (kHz)
• 250
• Switching frequency (Max) (kHz)
• 1000
• Features
• Enable, Frequency Synchronization, Power Good, Pre-Bias Start-Up, Synchronous Rectification, Tracking
• Regulated outputs (#)
• 1
• Number of phases
• 1
• Rating
• Catalog

LM2745的完整型号有：LM2745MTC/NOPB、LM2745MTCX/NOPB，以下是这些产品的关键参数及官网采购报价：

LM2745MTC/NOPB，工作温度：-40 to 125，封装：TSSOP (PW)-14，包装数量MPQ：94个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网LM2745MTC/NOPB的批量USD价格：.988（1000+）

LM2745MTCX/NOPB，工作温度：-40 to 125，封装：TSSOP (PW)-14，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网LM2745MTCX/NOPB的批量USD价格：.823（1000+）

LM2745-19AEVAL — 具有预偏置启动和可选时钟同步的同步降压控制器

This application notes describes the LM2745 printed circuit board (PCB) design and provides an example typical application circuit. The LM2745 is a voltage mode PWM buck controller which implements synchronous rectification. It provides a low cost, high power density, and efficient point of load (...)

PSPICE-FOR-TI — 适用于 TI 设计和模拟工具的 PSpice

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)