The LM5064 combines a high performance hot swap controller with a PMBus^TM compliant SMBus/I²C interface to accurately measure, protect and control the electrical operating conditions of systems connected to a backplane power bus. The LM5064 continuously supplies real-time power, voltage, current, temperature and fault data to the system management host via the SMBus interface.

The LM5064 control block includes a unique hot swap architecture that provides current and power limiting to protect sensitive circuitry during insertion of boards into a live system backplane, or any other "hot" power source. A fast acting circuit breaker prevents damage in the event of a short circuit on the output. The input under-voltage and over-voltage levels and hysteresis are configurable, as well as the insertion delay time and fault detection time. A temperature monitoring block on the LM5064 interfaces with a low-cost external diode for monitoring the temperature of the external MOSFET or other thermally sensitive components. The PGD output provides a fast indicator when the input and/or output voltages are outside their programmed ranges.

The LM5064 monitoring circuit computes both the real-time and average values of subsystem operating parameters (V_IN, I_IN, P_IN, V_OUT) as well as the peak power. Accurate power averaging is accomplished by averaging the product of the input voltage and current. A black box (Telemetry/Fault Snapshot) function captures and stores telemetry data and device status in the event of a warning or a fault.

• Input Voltage Range: -10V to -80V
• Programmable 26 mV or 50 mV Current Limit Threshold with Power Limiting (MOSFET Power Dissipation Limiting)
• Real Time Monitoring of VIN, VOUT, IIN, PIN, VAUX with 12-Bit Resolution and 1 kHz Sampling Rate
• Configurable Circuit Breaker Protection for Hard Shorts
• Configurable Under-Voltage and Over-Voltage Protection
• Remote Temperature Sensing with Programmable Warning and Shutdown Thresholds
• Detection and Notification of Damaged MOSFET Condition
• Power Measurement Accuracy: ±4.5% Over Temperature
• True Input Power Averages Dynamic Power Readings
• Averaging of VIN, IIN, PIN, and VOUT Over Programmable Interval Ranging from 0.001 to 4 Seconds
• Programmable WARN and FAULT Thresholds with SMBA Notification
• Black Box Capture of Telemetry Measurements and Device Status Triggered by WARN or FAULT Condition
• I2C/SMBus Interface and PMBus Compliant Command Structure
• Full Featured Application Development Software
• HTSSOP-28 Package

• FET
• External
• Vin (Min) (V)
• -80
• Vin (Max) (V)
• -10
• Vabsmax_cont (V)
• 100
• Current limit (Min) (A)
• 0.01
• Current limit (Max) (A)
• 500
• Overcurrent response
• Circuit breaker, Current limiting
• Fault response
• Auto-retry, Latch-off

LM5064的完整型号有：LM5064PMH/NOPB、LM5064PMHE/NOPB、LM5064PMHX/NOPB，以下是这些产品的关键参数及官网采购报价：

LM5064PMH/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-28，包装数量MPQ：48个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：SN，TI官网LM5064PMH/NOPB的批量USD价格：2.747（1000+）

LM5064PMHE/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-28，包装数量MPQ：250个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：SN，TI官网LM5064PMHE/NOPB的批量USD价格：2.747（1000+）

LM5064PMHX/NOPB，工作温度：-40 to 125，封装：HTSSOP (PWP)-28，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：SN，TI官网LM5064PMHX/NOPB的批量USD价格：2.289（1000+）

LM5064EVK — 用于 LM5064 的评估板

The LM5064EVK evaluation module provides the power design engineer with a fully functional intelligent monitoring and protection controller board designed for negative voltage systems. This application note describes the various functions of the board, how to test and evaluate it, and how to use (...)

PI-Commander EVM GUI

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)