TI代理,常备极具竞争力的充足现货
TI哪些型号被关注? TI热门产品型号
SN74LVTH162373的基本参数
  • 制造厂商:TI
  • 产品类别:逻辑和电压转换
  • 技术类目:触发器、锁存器和寄存器 - D 型锁存器
  • 功能描述:具有三态输出的 3.3V ABT 16 位透明 D 类锁存器
  • 点击这里打开及下载SN74LVTH162373的技术文档资料
  • TI代理渠道,提供当日发货、严格的质量标准,满足您的目标价格
快速报价,在行业拥有较高的知名度及影响力
SN74LVTH162373的产品详情:

The 'LVTH162373 devices are16-bit transparent D-type latches with 3-state outputs designed for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment. These devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.

A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without interface or pullup components.

OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.

The outputs, which are designed to source or sink up to 12 mA, include equivalent 22- series resistors to reduce overshoot and undershoot.

Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.

When VCC is between 0 and 1.5 V, the devices are in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

These devices are fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.

These devices can be used as two 8-bit latches or one 16-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.

SN74LVTH162373的优势和特性:
  • Members of the Texas Instruments Widebus? Family
  • Output Ports Have Equivalent 22- Series Resistors, So No External Resistors Are Required
  • Support Mixed-Mode Signal Operation (5-V Input and Output Voltages With 3.3-V VCC)
  • Support Unregulated Battery Operation Down to 2.7 V
  • Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C
  • Ioff and Power-Up 3-State Support Hot Insertion
  • Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
  • Distributed VCC and GND Pins Minimize High-Speed Switching Noise
  • Flow-Through Architecture Optimizes PCB Layout
  • Latch-Up Performance Exceeds 500 mA Per JESD 17
  • ESD Protection Exceeds JESD 22
    • 2000-V Human-Body Model (A114-A)
    • 200-V Machine Model (A115-A)

Widebus is a trademark of Texas Instruments.

SN74LVTH162373的参数(英文):
  • Number of channels (#)
  • 16
  • Technology Family
  • LVT
  • Supply voltage (Min) (V)
  • 2.7
  • Supply voltage (Max) (V)
  • 3.6
  • Input type
  • TTL-Compatible CMOS
  • Output type
  • 3-State
  • Clock Frequency (Max) (MHz)
  • 160
  • IOL (Max) (mA)
  • 12
  • IOH (Max) (mA)
  • -12
  • ICC (Max) (uA)
  • 5000
  • Features
  • Balanced outputs, Ultra high speed (tpd <5ns), Over-voltage tolerant inputs, Partial power down (Ioff), Power up 3-state, Damping resistors, Bus-hold, Flow-through pinout
SN74LVTH162373具体的完整产品型号参数及价格(美元):

SN74LVTH162373的完整型号有:SN74LVTH162373DGGR、SN74LVTH162373DL、SN74LVTH162373DLR,以下是这些产品的关键参数及官网采购报价:

SN74LVTH162373DGGR,工作温度:-40 to 85,封装:TSSOP (DGG)-48,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DGGR的批量USD价格:.479(1000+)

SN74LVTH162373DL,工作温度:-40 to 85,封装:SSOP (DL)-48,包装数量MPQ:25个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DL的批量USD价格:.623(1000+)

SN74LVTH162373DLR,工作温度:-40 to 85,封装:SSOP (DL)-48,包装数量MPQ:1000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DLR的批量USD价格:.527(1000+)

轻松满足您的TI芯片采购需求
SN74LVTH162373的评估套件:

SN74LVTH162373DGGR,工作温度:-40 to 85,封装:TSSOP (DGG)-48,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DGGR的批量USD价格:.479(1000+)

SN74LVTH162373DL,工作温度:-40 to 85,封装:SSOP (DL)-48,包装数量MPQ:25个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DL的批量USD价格:.623(1000+)

SN74LVTH162373DLR,工作温度:-40 to 85,封装:SSOP (DL)-48,包装数量MPQ:1000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网SN74LVTH162373DLR的批量USD价格:.527(1000+)

TI代理|TI中国代理 - 国内领先的TI芯片采购平台
丰富的可销售TI代理库存,专业的销售团队可随时响应您的紧急需求,目标成为有价值的TI代理