The TLC6C598-Q1 is a monolithic, medium-voltage, low-current power 8-bit shift register designed for use in systems that require relatively moderate load power, such as LEDs.

This device contains an 8-bit serial-in, parallel-out shift register that feeds an 8-bit D-type storage register. Data transfers through both the shift and storage registers on the rising edge of the shift-register clock (SRCK) and the register clock (RCK), respectively. The storage register transfers data to the output buffer when shift register clear (CLR) is high. A low on CLR clears all registers in the device. Holding the output enable (G) high, holds all data in the output buffers low, and all drain outputs are off. Holding G low makes data from the storage register transparent to the output buffers. When data in the output buffers is low, the DMOS transistor outputs are off. When data is high, the DMOS transistor outputs have sink-current capability. The serial output (SER OUT) clocks out of the device on the falling edge of SRCK to provide additional hold time for cascaded applications. This provides improved performance for applications where clock signals may be skewed, devices are not located near one another, or the system must tolerate electromagnetic interference. The device contains built-in thermal shutdown protection.

Outputs are low-side, open-drain DMOS transistors with output ratings of 40 V and 50 mA continuous sink-current capabilities when Vcc = 5 V. The current limit decreases as the junction temperature increases for additional device protection. The device also provides up to 2000 V of ESD protection when tested using the human-body model and 200 V when using the machine model.

The TLC6C598-Q1 characterization is for for operation over the operating ambient temperature range of −40°C to 125°C.

• Qualified for Automotive Applications
• AEC-Q100 Qualified With the Following Results:
  • Device Temperature Grade 1: –40°C to 125°C Ambient Operating Temperature Range
  • Device HBM ESD Classification Level H2
  • Device CDM ESD Classification Level C3B
• Wide Vcc From 3 V to 5.5 V
• Output Maximum Rating of.40 V
• Eight Power DMOS Transistor Outputs of 50-mA Continuous Current With VCC = 5 V
• Thermal Shutdown Protection
• Enhanced Cascading for Multiple Stages
• All Registers Cleared With Single Input
• Low Power Consumption
• Slow Switching Time (tr and tf), Which Helps Significantly With Reducing EMI
• 16-Pin TSSOP-PW Package
• 16-Pin SOIC-D Package

• Number of channels (#)
• 8
• Topology
• Open drain
• Rating
• Automotive
• Operating temperature range (C)
• -40 to 125
• Vin (Min) (V)
• 3
• Vin (Max) (V)
• 5.5
• Vout (Min) (V)
• 0
• Vout (Max) (V)
• 40
• Iout (Max) (A)
• 0.4
• Features
• Thermal Shutdown

TLC6C598-Q1的完整型号有：TLC6C598CQDRQ1、TLC6C598QPWRQ1，以下是这些产品的关键参数及官网采购报价：

TLC6C598CQDRQ1，工作温度：-40 to 125，封装：SOIC (D)-16，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：NIPDAU，TI官网TLC6C598CQDRQ1的批量USD价格：.383（1000+）

TLC6C598QPWRQ1，工作温度：-40 to 125，封装：TSSOP (PW)-16，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：NIPDAU，TI官网TLC6C598QPWRQ1的批量USD价格：.343（1000+）

TLC6C598 Unencrypted PSpice Transient Model Package (Rev. B)

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)

TIDA-010076 — Daisy-chained power and data over single pair Ethernet (T1) reference design

TIDA-010076 展示了如何通过 SPE 传输 220W 的电力和 100Mbit/s 的数据。与星型拓扑中的常规系统相比，菊花链拓扑中的通信系统需要的硬件和布线明显更少。与单对以太网（SPE，100BASE-T1）及数据线供电结合使用时，该设计可以减少接线，实现简化。电力和数据仅通过两条导线从一个节点输送到另一个节点。