The TLV320AIC14 implements the smart time division multiplexed serial port (SMARTDM™). This is TI’s design innovation to optimize DSP performance with its most advanced synchronous serial port in TDM format for glue-free interface to popular DSPs (i.e., C5x, C6x) and microcontrollers. The SMARTDM supports both continuous data transfer mode and on-the-fly reconfiguration programming mode. SMARTDM maximizes the bandwidth of data transfer between the TLV320AIC14 DSP codec and the DSP. In normal operation, it automatically detects the number of codecs in the serial interface and adjusts the number of time slots to match the number of codecs so that no time slot in the TDM frame is wasted. In the turbo mode, it maintains the same number of time slots but maximizes the bit transferred rate to 25 MHz to give the DSP more bandwidth to process other tasks in the same sampling period. The SMARTDM technology allows up to 16 codecs to share a single 4-wire serial bus.

The TLV320AIC14 also provides a flexible host port. The host port interface is a two-wire serial interface that can be programmed to be either an industrial standard I²C or a simple S²C (start-stop communication protocol).

The TLV320AIC14 also integrates all of the critical functions needed for most voice-band applications including MIC preamp, handset/headset preamps, antialiasing filter (AAF), input/output programmable gain amplifier (PGA), and selectable low-pass IIR/FIR filters.

The TLV320AIC14 implements an extensive power management; including device power-down, independent software control for turning off ADC, DAC, op-amps, and IIR/FIR filter (bypassable) to maximize system power conservation. The TLV320AIC14 consumes only 10 mW at 3 V.

The TLV320AIC14’s low power operation from 2.7 V to 3.6 V for analog and I/O and 1.65 V to 1.95 V for digital core power supplies, along with extensive power management, make it ideal for portable applications including wireless accessories, hands free car kits, VOIP, cable modem, and speech processing. Its low group delay characteristic makes it suitable for single or multichannel active control applications.

The TLV320AIC14 is characterized for commercial operation from 0°C to 70°C and industrial operation from –40°C to 85°C.

• C54x Software Driver Available
• 16-Bit Oversampling Sigma-Delta A/D Converter
• 16-Bit Oversampling Sigma-Delta D/A Converter
• Support Maximum Master Clock of 100 MHz to Allow DSPs Output Clock to Be Used as Master Clock
• Selectable FIR/IIR Filter With Bypassing Option
• Programmable Sampling Rate up to:
  • Max 26 KSPS With On-Chip IIR/FIR Filter
  • Max 104 KSPS With IIR/FIR Bypassed
• On-Chip FIR Produced 84-dB SNR for ADC and 91-dB SNR for DAC Over 13-kHz BW
• External DSPs IIR/FIR for a Final Sampling Rate of 8 Ksps (IIR/FIR Bypassed) Produced 87-dB SNR for ADC and 92-dB SNR for DAC.
• Smart Time Division Multiplexed Serial Port (SMARTDM)
  • Glueless 4-Wire Interface to DSP
  • Automatic Cascade Detection (ACD) Self-Generates Master/Slave Device Addresses
  • Programming Mode to Allow On-the-Fly Reconfiguration
  • Continuous Data Transfer Mode to Support DSP’s DMA/Autobuffering Mode
  • Turbo Mode to Maximize Bit Clock for Faster Data Transfer and Higher Data Bandwidth
  • Total Number of Time Slots Dynamically Proportional to Number of Codecs in the Cascade to Eliminate Unused Time Slots and Optimize DSP Memory Allocation
  • Allows up to 16 Codecs to Be Connected to a Single Serial Port
• Host Port
  • 2-Wire Interface
  • Selectable I2C or S2C
• Differential and Single-Ended Analog Input/Output
• Built-In Functions:
  • Sidetone
  • Antialiasing Filter (AAF)
  • Programmable Input and Output Gain Control (PGA)
  • Microphone Amplifiers
  • Power Management With Hardware/Software Power-Down Modes 30 uW
• Separate Software Control for ADC and DAC Power Down
• Fully Compatible With TI C54x DSP Power Supplies
  • 1.65 V–1.95 V Digital Core Power
  • 2.7 V–3.6 V Digital I/O
  • 2.7 V–3.6 V Analog
• Power Dissipation (PD) 10 mW at 3 V in Standard Operation
• Internal Reference Voltage (Vref)
• 2s Complement Data Format
• Test Mode Which Includes Digital Loopback and Analog Loopback

SMARTDM is a trademark of Texas Instruments. NOTE: This product temporarily requires a waiver signed by the customer before orders can be shipped. A product notification sheet is provided in the data sheets. Please send email to shipping-waivers@list.ti.com for details.

• Number of ADC channels
• 1
• Number of DAC channels (#)
• 1
• Digital audio interface
• DSP, SMART TDM
• Analog inputs
• 3
• Sampling rate (Max) (kHz)
• 26
• Rating
• Catalog
• ADC SNR (Typ) (dB)
• 84
• DAC SNR (Typ) (dB)
• 92

TLV320AIC14的完整型号有：TLV320AIC14CDBT、TLV320AIC14CDBTR、TLV320AIC14IDBT、TLV320AIC14IDBTR，以下是这些产品的关键参数及官网采购报价：

TLV320AIC14CDBT，工作温度：0 to 70，封装：TSSOP (DBT)-30，包装数量MPQ：60个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TLV320AIC14CDBT的批量USD价格：8.4（1000+）

TLV320AIC14CDBTR，工作温度：0 to 70，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TLV320AIC14CDBTR的批量USD价格：7（1000+）

TLV320AIC14IDBT，工作温度：-40 to 85，封装：TSSOP (DBT)-30，包装数量MPQ：60个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TLV320AIC14IDBT的批量USD价格：9.24（1000+）

TLV320AIC14IDBTR，工作温度：-40 to 85，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TLV320AIC14IDBTR的批量USD价格：7.84（1000+）

PSPICE-FOR-TI — 适用于 TI 设计和模拟工具的 PSpice

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)