The TMS320VC5507 fixed-point digital signal processor (DSP) is based on the TMS320C55x DSP generation CPU processor core. The C55x™ DSP architecture achieves high performance and low power through increased parallelism and total focus on reduction in power dissipation. The CPU supports an internal bus structure that is composed of one program bus, three data read buses, two data write buses, and additional buses dedicated to peripheral and DMA activity. These buses provide the ability to perform up to three data reads and two data writes in a single cycle. In parallel, the DMA controller can perform up to two data transfers per cycle independent of the CPU activity.

The C55x CPU provides two multiply-accumulate (MAC) units, each capable of 17-bit × 17-bit multiplication in a single cycle. A central 40-bit arithmetic/logic unit (ALU) is supported by an additional 16-bit ALU. Use of the ALUs is under instruction set control, providing the ability to optimize parallel activity and power consumption. These resources are managed in the Address Unit (AU) and Data Unit (DU) of the C55x CPU.

The C55x DSP generation supports a variable byte width instruction set for improved code density. The Instruction Unit (IU) performs 32-bit program fetches from internal or external memory and queues instructions for the Program Unit (PU). The Program Unit decodes the instructions, directs tasks to AU and DU resources, and manages the fully protected pipeline. Predictive branching capability avoids pipeline flushes on execution of conditional instructions.

The 128K bytes of on-chip memory on 5507 is sufficient for many hand-held appliances, portable GPS systems, wireless speaker phones, portable PDAs, and gaming devices. Many of these appliances typically require 64K bytes or more on-chip memory but less than 128K bytes of memory, and need to operate in standby mode for more than 60% to 70% of time. For the applications which require more than 128K bytes of on-chip memory but less than 256K bytes of on-chip memory, Texas Instruments (TI) offers the TMS320VC5509A device, which is based on the TMS320C55x DSP core.

The general-purpose input and output functions and the 10-bit A/D provide sufficient pins for status, interrupts, and bit I/O for LCDs, keyboards, and media interfaces. The parallel interface operates in two modes, either as a slave to a microcontroller using the HPI port or as a parallel media interface using the asynchronous EMIF. Serial media is supported through three McBSPs.

The 5507 peripheral set includes an external memory interface (EMIF) that provides glueless access to asynchronous memories like EPROM and SRAM, as well as to high-speed, high-density memories such as synchronous DRAM. Additional peripherals include Universal Serial Bus (USB), real-time clock, watchdog timer, and I²C multi-master and slave interface. Three full-duplex multichannel buffered serial ports (McBSPs) provide glueless interface to a variety of industry-standard serial devices, and multichannel communication with up to 128 separately enabled channels. The enhanced host-port interface (HPI) is a 16-bit parallel interface used to provide host processor access to 32K bytes of internal memory on the 5507. The HPI can be configured in either multiplexed or non-multiplexed mode to provide glueless interface to a wide variety of host processors. The DMA controller provides data movement for six independent channel contexts without CPU intervention, providing DMA throughput of up to two 16-bit words per cycle. Two general-purpose timers, up to eight dedicated general-purpose I/O (GPIO) pins, and digital phase-locked loop (DPLL) clock generation are also included.

The 5507 is supported by the industry’s award-winning eXpressDSP™, Code Composer Studio™ Integrated Development Environment (IDE), DSP/BIOS™, Texas Instruments’ algorithm standard, and the industry‘s largest third-party network. The Code Composer Studio IDE features code generation tools including a C Compiler and Visual Linker, simulator, RTDX™, XDS51™. emulation device drivers, and evaluation modules. The 5507 is also supported by the C55x DSP Library which features more than 50 foundational software kernels (FIR filters, IIR filters, FFTs, and various math functions) as well as chip and board support libraries.

• High-Performance, Low-Power, Fixed-Point TMS320C55? Digital Signal Processor
  • 9.26-, 6.95-, 5-ns Instruction Cycle Time
  • 108-, 144-, 200-MHz Clock Rate
  • One/Two Instruction(s) Executed per Cycle
  • Dual Multipliers [Up to 400 Million Multiply-Accumulates per Second (MMACS)]
  • Two Arithmetic/Logic Units (ALUs)
  • Three Internal Data/Operand Read Buses and Two Internal Data/Operand Write Buses
• 64K × 16-Bit On-Chip RAM, Composed of:
  • 64K Bytes of Dual-Access RAM (DARAM) 8 Blocks of 4K × 16-Bit
  • 64K Bytes of Single-Access RAM (SARAM) 8 Blocks of 4K × 16-Bit
• 64K Bytes of One-Wait-State On-Chip ROM (32K × 16-Bit)
• 8M × 16-Bit Maximum Addressable External Memory Space (Synchronous DRAM)
• 16-Bit External Parallel Bus Memory Supporting Either:
  • External Memory Interface (EMIF) With GPIO Capabilities and Glueless Interface to:
    • Asynchronous Static RAM (SRAM)
    • Asynchronous EPROM
    • Synchronous DRAM (SDRAM)
  • 16-Bit Parallel Enhanced Host-Port Interface (EHPI) With GPIO Capabilities
• Programmable Low-Power Control of Six Device Functional Domains
• On-Chip Scan-Based Emulation Logic
• On-Chip Peripherals
  • Two 20-Bit Timers
  • Watchdog Timer
  • Six-Channel Direct Memory Access (DMA) Controller
  • Three Multichannel Buffered Serial Ports (McBSPs)
  • Programmable Phase-Locked Loop Clock Generator
  • Seven (LQFP) or Eight (BGA) General-Purpose I/O (GPIO) Pins and a General- Purpose Output Pin (XF)
  • USB Full-Speed (12 Mbps) Slave Port Supporting Bulk, Interrupt and Isochronous Transfers
  • Inter-Integrated Circuit (I2C) Multi-Master and Slave Interface
  • Real-Time Clock (RTC) With Crystal Input, Separate Clock Domain, Separate Power Supply
  • 4-Channel (BGA) or 2-Channel (LQFP) 10-Bit Successive Approximation A/D
• IEEE Std 1149.1(1) (JTAG) Boundary Scan Logic
• Packages:
  • 144-Terminal Low-Profile Quad Flatpack (LQFP) (PGE Suffix)
  • 179-Terminal MicroStar BGA? (Ball Grid Array) (GHH and ZHH Suffixes)
• 1.2-V Core (108 MHz), 2.7-V - 3.6-V I/Os
• 1.35-V Core (144 MHz), 2.7-V - 3.6-V I/Os
• 1.6-V Core (200 MHz), 2.7-V - 3.6-V I/Os

C55x is a trademark of Texas Instruments. TMS320C55x and MicroStar BGA are trademarks of Texas Instruments. All trademarks are the property of their respective owners. (1)IEEE Standard 1149.1-1990 Standard-Test-Access Port and Boundary Scan Architecture.

• DSP
• 1 C55x
• DSP MHz (Max)
• 108, 144, 200
• CPU
• 16-bit
• Operating system
• DSP/BIOS, VLX
• Rating
• Catalog
• Operating temperature range (C)
• -40 to 85

TMS320VC5507的完整型号有：TMS320VC5507GBB、TMS320VC5507PGE、TMS320VC5507ZAY、TMS320VC5507ZAYR，以下是这些产品的关键参数及官网采购报价：

TMS320VC5507GBB，工作温度：-40 to 85，封装：NFBGA (GBB)-179，包装数量MPQ：160个，MSL 等级/回流焊峰值温度：Level-3-220C-168 HR，引脚镀层/焊球材料：SNPB，TI官网TMS320VC5507GBB的批量USD价格：9.49（1000+）

TMS320VC5507PGE，工作温度：-40 to 85，封装：LQFP (PGE)-144，包装数量MPQ：60个，MSL 等级/回流焊峰值温度：Level-4-260C-72 HR，引脚镀层/焊球材料：NIPDAU，TI官网TMS320VC5507PGE的批量USD价格：9.49（1000+）

TMS320VC5507ZAY，工作温度：-40 to 85，封装：NFBGA (ZAY)-179，包装数量MPQ：160个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：SNAGCU，TI官网TMS320VC5507ZAY的批量USD价格：11.388（1000+）

TMS320VC5507ZAYR，工作温度：-40 to 85，封装：NFBGA (ZAY)-179，包装数量MPQ：1000个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：SNAGCU，TI官网TMS320VC5507ZAYR的批量USD价格：9.49（1000+）

TMDSEMU200-U — Spectrum Digital XDS200 USB 仿真器

Spectrum Digital XDS200 是最新 XDS200 系列 TI 处理器调试探针（仿真器）的首个模型。XDS200 系列拥有超低成本 XDS100 与高性能 XDS560v2 之间的低成本与高性能的完美平衡。此外，对于带有嵌入式缓冲跟踪器 (ETB) 的所有 ARM 和 DSP 处理器，所有 XDS 调试探针均支持内核和系统跟踪。

Spectrum Digital XDS200 通过 TI 20 引脚连接器（带有适合 TI 14 引脚、TI 10 引脚和 ARM 20 引脚的多个适配器）连接到目标板，而通过 USB2.0 高速连接 (480Mbps) 连接到主机 PC。要在主机 (...)

TMDSEMU560V2STM-U — Blackhawk XDS560v2 系统跟踪 USB 仿真器

XDS560v2 System Trace 是 XDS560v2 系列高性能 TI 处理器调试探针（仿真器）的第一种型号。XDS560v2 是 XDS 系列调试探针中性能最高的一款，同时支持传统 JTAG 标准 (IEEE1149.1) 和 cJTAG (IEEE1149.7)。

XDS560v2 System Trace 在其巨大的外部存储器缓冲区中加入了系统引脚跟踪。这种外部存储器缓冲区适用于指定的 TI 器件，通过捕获相关器件级信息，获得准确的总线性能活动和吞吐量，并对内核和外设进行电源管理。此外，对于带有嵌入式缓冲跟踪器 (ETB) 的所有 ARM 和 DSP 处理器，所有 XDS (...)

TMDSEMU560V2STM-UE — Spectrum Digital XDS560v2 系统跟踪 USB 和以太网

XDS560v2 System Trace 是 XDS560v2 系列高性能 TI 处理器调试探针（仿真器）的第一种型号。XDS560v2 是 XDS 系列调试探针中性能最高的一款，同时支持传统 JTAG 标准 (IEEE1149.1) 和 cJTAG (IEEE1149.7)。

XDS560v2 System Trace 在其巨大的外部存储器缓冲区中加入了系统引脚跟踪。这种外部存储器缓冲区适用于指定的 TI 器件，通过捕获相关器件级信息，获得准确的总线性能活动和吞吐量，并对内核和外设进行电源管理。此外，对于带有嵌入式缓冲跟踪器 (ETB) 的所有 ARM 和 DSP 处理器，所有 XDS (...)

C55XCODECSAUD — 用于 C55x 的音频编解码器 - 软件和文档

The DSP Library (DSPLIB) is a collection of high-level optimized DSP function modules for the C55x DSP platform. This source-code library includes C-callable functions (ANSI-C language compatible) for general signal processing math and vector functions that have been ported to C55x DSPs. The (...)

TELECOMLIB — 用于 TMS320C64x+ 和 TMS320C55x 处理器的电信和媒体库 - FAXLIB、VoLIB 和 AEC/AER

Voice Library- VoLIBprovides components that, together, facilitate the development of the signal processing chain for Voice over IP applications such as infrastructure, enterprise, residential gateways and IP phones. Together with optimized implementations of ITU-T voice codecs, that can be (...)

VC5507 PGE BSDL Model

TI has partnered with companies to offer a wide range of software, tools, and SOMs using TI processors to accelerate your path to production. Download this search tool to quickly browse our third-party solutions and find the right third-party to meet your needs. The software, tools and modules (...)