The TPIC44H01 is a four channel high-side pre-FET driver which provides serial or parallel input interface to control four external NMOS power FETs. It is designed for use in low frequency switching applications for resistive or inductive loads, including solenoids and incandescent bulbs.

Each channel has over-current, short-to-ground, and open-load detection that is flagged through the FLT\ pin and distinguished through the serial interface. Over-current thresholds are set through the V_{(PK_x)} and V_(COMP1-4) pins. Short-to-ground and open-load thresholds are set internally to approximately 2.5 V. The AR_ENBL pin is used to define the operation of the device during a fault condition, allowing the outputs to either latch off or to enter a low duty cycle, auto-retry mode. An over-voltage lockout circuit on V_(PWR) protects the device and the external FETs. A low current sleep state mode is provided to allow the TPIC44H01 to be used in applications where V_(PWR) is connected directly to the battery. An internal charge pump allows the use of N-channel FETs for high-side drive applications, while current-limit gate drive provides slope control for reduced RFI.

By having the unique ability to develop a dynamic over-current threshold, the TPIC44H01 can be used to drive incandescent bulbs with long inrush currents without falsely flagging a fault. Likewise, the user can select an internally set over-current threshold of ~1.25 V by pulling the respective V_(COMP1-4) pin to V_CC.

The 8-bit serial peripheral interface (SPI) allows the user to command any of the four outputs on or off, to program one of eight possible open-load, over-current, and short-load fault deglitch timer settings, and to engage the sleep state. Data is clocked into the SDI pin on the rising edge of SCLK and clocked out of the SDO pin on the SCLK falling edge. The serial input bits are logic OR'ed with the IN1-IN4 parallel inputs pins. The serial interface is also used to read normal-load, open-load, over-current, and short-to-ground conditions for each channel. Over-voltage lockout can be detected when the FLT\ pin is low and no bits are set in the SDO register. Multiple TPIC44H01 devices may be cascaded together using the serial interface to further reduce I/O lines from the host controller.

• Serial or Parallel Control of Gate Outputs
• Sleep State for Low Quiescent Current
• Independent On-State Source Short-to-Ground (Shorted-Load) Detection/Protection
• Independent On-State Over-Current Detection/Protection With Dynamic Fault Threshold
• Independent Off-State Open-Load Detection
• Supply Over-Voltage Lockout Protection
• Asynchronous Open-Drain Fault Interrupt Terminal to Flag Fault Conditions. Output Can be OR'ed With Multiple Devices
• Encoded Fault Status Reporting Through Serial Output Terminal (2-Bits Per Channel)
• Programmable On-State Fault Deglitch Timers
• High Impedance CMOS Compatible Inputs With Hysteresis
• Fault Mode Selection: Outputs Latched Off or Switched at Low Duty Cycle
• Device Can be Cascaded With Serial Interface

TI is a trademark of Texas Instruments Incorporated.

• Number of channels (#)
• 4
• Power switch
• MOSFET
• Peak output current (A)
• 0.004
• Input VCC (Min) (V)
• 8
• Input VCC (Max) (V)
• 24
• Features
• SPI Interface, Sleep mode, OVP, Fault Diagnostics
• Operating temperature range (C)
• -40 to 125
• Rise time (ns)
• 5000
• Fall time (ns)
• 5000
• Prop delay (ns)
• 5000
• Input threshold
• CMOS
• Channel input logic
• Non-Inverting
• Input negative voltage (V)
• -0.3
• Rating
• Automotive
• Driver configuration
• Quad inputs

TPIC44H01的完整型号有：TPIC44H01DA、TPIC44H01DAG4、TPIC44H01DAR，以下是这些产品的关键参数及官网采购报价：

TPIC44H01DA，工作温度：-40 to 125，封装：TSSOP (DA)-32，包装数量MPQ：46个，MSL 等级/回流焊峰值温度：Level-1-220C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网TPIC44H01DA的批量USD价格：2.064（1000+）

TPIC44H01DAG4，工作温度：PropertyValue，封装：TSSOP (DA)-32，包装数量MPQ：46个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPIC44H01DAG4的批量USD价格：2.322（1000+）

TPIC44H01DAR，工作温度：-40 to 125，封装：TSSOP (DA)-32，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网TPIC44H01DAR的批量USD价格：1.72（1000+）

PSPICE-FOR-TI — 适用于 TI 设计和模拟工具的 PSpice

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)

TIDA-00296 — 汽车车身控制模块驱动器参考设计

TIDA-00296 是一项重点介绍 TI 高侧和低侧继电器、电机以及负载驱动器产品系列的参考设计。我们选择了针对该设计的负载（门锁、车窗升降电机、座椅加热器、HVAC、车灯和 LED）来展示 BCM 可驱动的负载范围以及 TI 解决方案如何满足这些领域。