The TPS40200-Q1 is a flexible, nonsynchronous controller with a built-in 200-mA driver for P-channel FETs. The circuit operates with inputs up to 52 V, with a power-saving feature that turns off driver current once the external FET has been turned on fully. This feature extends the flexibility of the device, allowing it to operate with an input voltage up to 52 V without dissipating excessive power. The circuit operates with voltage-mode feedback and has feed-forward input-voltage compensation that responds instantly to input voltage change. The integral 700-mV reference is trimmed to 2%, providing the means to accurately control low voltages. The TPS40200-Q1 is available in an 8-pin SOIC package and supports many of the features of more complex controllers. Clock frequency, soft start, and overcurrent limit are each easily programmed by a single, external component. The device has undervoltage lockout (UVLO) and can be easily synchronized to other controllers or a system clock to satisfy sequencing and/or noise-reduction requirements.

• Qualified for Automotive Applications
• AEC-Q100 Qualified With the Following Results:
  • Device Temperature Grade 1: –40°C to 125°C
  • Device HBM ESD Classification Level 1B
  • Device CDM ESD Classification Level C6
• Input Voltage Range 4.5V to 52V
• Output Voltage (700mV to 90%VIN)
• 200-mA Internal P-channel FET Driver
• Voltage Feed-Forward Compensation
• Undervoltage Lockout (UVLO)
• Programmable Fixed-Frequency (35-kHzto 500-kHz) Operation
• Programmable Short-Circuit Protection
• Hiccup Overcurrent Fault Recovery
• Programmable Closed-Loop Soft Start
• 700-mV 1% Reference Voltage
• External Synchronization
• Small 8-Pin SOIC (D) Package

• Vin (Min) (V)
• 4.5
• Vin (Max) (V)
• 52
• Vout (Min) (V)
• 0.7
• Vout (Max) (V)
• 46
• Iout (Max) (A)
• 3
• Iq (Typ) (uA)
• 1500
• Switching frequency (Min) (kHz)
• 35
• Switching frequency (Max) (kHz)
• 500
• Features
• Frequency Synchronization
• Regulated outputs (#)
• 1
• Number of phases
• 1
• Rating
• Automotive

TPS40200-Q1的完整型号有：TPS40200QDRQ1，以下是这些产品的关键参数及官网采购报价：

TPS40200QDRQ1，工作温度：-40 to 125，封装：SOIC (D)-8，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网TPS40200QDRQ1的批量USD价格：.834（1000+）

TPS40200EVM-001 — TPS40200 12V 输入、3.3V 输出、2.5A 评估模块

TPS40200EVM-001 is designed to operate with an 8V to 16V input and to produce a regulated 3.3V output with a load current from 0.125A to 2.5A. The TPS40200EVM-001 demonstrates the use of the TPS40200 in a typical buck converter application. The board sacrifices some (...)

TPS40200-Q1 Unencrypted PSpice Transient Model Package (Rev. A)

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)

PMP4629 — Non sync buck 4.3V@3A

此参考设计支持使用 TPS40200-Q1 为安全跟踪器供电，可允许 8V-50V 的宽输入电压范围。由于采用非同步降压控制器，因此其输出可处理 4.3V，最高为 3A。此参考设计由于采用该器件提供简单配置，因此设计十分灵活。