The TPS5120 is a dual channel, high-efficiency synchronous buck controller where the outputs run 180 degrees out of phase, which lowers the input current ripple, thereby reducing the input capacitance cost. The PWM/SKIP pin allows the operating mode to switch from PWM mode to skip mode under light load conditions. The skip mode enables a lower operating frequency and shortens the pulse width to the low-side MOSFET, increasing the efficiency under light load conditions. These two modes, along with synchronous-rectifier drivers, dead time, and very low quiescent current, allow power to be conserved and the battery life to be extended under all load conditions. The 1.5 A (typical) high-side and low-side MOSFET drivers on-chip are designed to drive less expensive N-channel MOSFETs. The resistorless current protection and fixed high-side driver voltage simplify the power supply design and reduce the external parts count. Each channel is independent, offering a separate controller, overcurrent protection, and standby control. Sequencing is flexible and can be tailored by choosing different softstart capacitor values. Other features, such as undervoltage lockout, power good, overvoltage, undervoltage, and programmable short-circuit protection promote system reliability.

• Controlled Baseline
  • One Assembly/Test Site, One Fabrication Site
• Extended Temperature Performance of –55°C to 125°C
• Enhanced Diminishing Manufacturing Sources (DMS) Support
• Enhanced Product-Change Notification
• Qualification Pedigree
• Independent Dual-Outputs Operate 180° Out of Phase
• Wide Input Voltage Range: 4.5-V – 28-V
• Adjustable Output Voltage Down to 0.9 V
• Pin-Selectable PWM/SKIP Mode for High Efficiency Under Light Loads
• Synchronous Buck Operation Allows up to 95% Efficiency
• Separate Standby Control and Overcurrent Protection for Each Channel
• Programmable Short-Circuit Protection
• Low Supply (1 mA) and Shutdown (1 nA) Current
• Power Good Output
• High-Speed Error Amplifiers
• Sequencing Easily Achieved by Selecting Softstart Capacitor Values.
• 5-V Linear Regulator Power Internal IC Circuitry
• 30-Pin TSSOP Packaging

Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life. Such qualification testing should not be viewed as justifying use of this component beyond specified performance and environmental limits.

• Vin (Min) (V)
• 4.5
• Vin (Max) (V)
• 28
• Vout (Min) (V)
• 0.9
• Vout (Max) (V)
• 26
• Iout (Max) (A)
• 1.5
• Iq (Typ) (uA)
• 1100
• Switching frequency (Min) (kHz)
• 100
• Switching frequency (Max) (kHz)
• 500
• Features
• Enable, Light Load Efficiency, Phase Interleaving, Power Good, Synchronous Rectification
• Regulated outputs (#)
• 2
• Number of phases
• 2
• Rating
• HiRel Enhanced Product

TPS5120-EP的完整型号有：TPS5120MDBTREP、TPS5120QDBTREP、V62/04645-01XE、V62/04645-02XE，以下是这些产品的关键参数及官网采购报价：

TPS5120MDBTREP，工作温度：-55 to 125，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS5120MDBTREP的批量USD价格：5.896（1000+）

TPS5120QDBTREP，工作温度：-40 to 125，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS5120QDBTREP的批量USD价格：5.896（1000+）

V62/04645-01XE，工作温度：-40 to 125，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网V62/04645-01XE的批量USD价格：5.896（1000+）

V62/04645-02XE，工作温度：-55 to 125，封装：TSSOP (DBT)-30，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网V62/04645-02XE的批量USD价格：5.896（1000+）

PSPICE-FOR-TI — 适用于 TI 设计和模拟工具的 PSpice

PSpice for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助?PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在?PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)