The TPS652x provides one PWM buck controller, two adjustable, synchronous buck regulators, two independent USB power switches and a supply voltage supervisor (SVS) to provide main power functions for satellite set top boxes, xDSL and cable modem applications operating off a single 12- to 22-V supply.

The SMPS have integrated switching FETs for optimized power efficiency and reduced external component count. Each USB switch provides up to 0.5-A (TPS65230) or 1-A (TPS65231) of current as required by downstream USB devices. All power blocks have thermal and over current/short circuit protection.

The SVS provides two inputs for monitoring positive supply rails. The active-low open-drain output remains low for at least 180 ms after all supply rails rise above their rising edge threshold. Threshold value for VMON1 input is set for monitoring a 3.3-V rail without the need for additional external components. Threshold for VMON2 input is set to 0.8 V and requires resistor dividers on the input to monitor any positive voltage in the system. The nBOR/nHOT open-drain output is pulled low if the input supply drops below 9.3 V or the chip temperature approaches the thermal shutdown limit. This allows the system processor to save critical data and shut down gracefully before the supply fails.

The TPS65230 and TPS65231 can be controlled either through parallel I/Os or through I²C interface. When the pull-up resistor on the USBFLAG2/nINT pin is connected to a 3.3-V or lower supply the I²C interface is disabled and the device is controlled through parallel I/O pins only. With the pull-up resistor connected to 6 V the I²C interface is enabled and the device is controlled by writing to the control registers. Any fault or abnormal operating condition is flagged by the interrupt pin. The interrupt is cleared by reading the status register via the I²C interface.

• Wide Input Supply Voltage Range (10.8 V - 22 V)
• One Adjustable PWM Buck Controller
  • 10.8-V – 22-V Input Voltage Range
  • 3.3-V – 6.1-V Output Voltage Range
  • 500kHz switching frequency
  • Type III Compensation
  • Programmable Current Limit
• Two Adjustable Step-Down Converter with Integrated Switching FETs:
  • 4.75-V - 5.5-V Input
  • 0.9-V-3.3-V Output Voltage Range
  • 3-A Output Current
  • 1-MHz Switching Frequency
  • Voltage Scaling Option
  • Type III Compensation
• Two 100-m, 0.5-A (TPS65230) 1-A (TPS65231) USB Switches with Over Current Protection and Open-Drain Fault Pin
• Early Supply Failure Flag (Open Drain Output) is Set when Input Voltage Drops Below 9.3 V
• Early Temperature Warning Flag (Open Drain Output) is Set if Temperature Approaches Shut-Down Threshold
• Supply Voltage Supervisor Circuit with Two Monitor Inputs and Open Drain Output
• Parallel I/O or I2C Control with User Selectable Address
• Advanced Fault Detection and Output Voltage Adjustment Options in I2C Mode
• Pull-Up Current Sources on Buck Enable Pins for Accurate Start-Up Timing Control with Preset Default
• Over Current Protection on All Rails
• Thermal Shutdown to Protect Device During Excessive Power Dissipation
• Thermally Enhanced Package for Efficient Heat Management (48-pin HTSSOP)
• APPLICATIONS
  • Digital Set Top Boxes
  • xDSL & Cable Modems
  • DVD Players
  • Home Gateway and Access Point Networks
  • Wireless Routers

• Regulated outputs (#)
• 3
• Vin (Min) (V)
• 10.8
• Vin (Max) (V)
• 22
• Iout (Max) (A)
• 3
• Rating
• Catalog
• LDO
• 0
• Features
• Programmable Current Limit, Voltage Scaling, Supply Voltage Supervisor Circuit, Fault Detection, Over Current Protection
• Switching frequency (Typ) (kHz)
• 1000
• Configurability
• Software configurable, User programmable

TPS65231A2的完整型号有：TPS65231A2DCAR，以下是这些产品的关键参数及官网采购报价：

TPS65231A2DCAR，工作温度：0 to 85，封装：HTSSOP (DCA)-48，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：NIPDAU，TI官网TPS65231A2DCAR的批量USD价格：3.115（1000+）

TPS65231A2DCAR，工作温度：0 to 85，封装：HTSSOP (DCA)-48，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-3-260C-168 HR，引脚镀层/焊球材料：NIPDAU，TI官网TPS65231A2DCAR的批量USD价格：3.115（1000+）