The TPS753xxQ and TPS751xxQ devices are low-dropout regulators with integrated power-on reset and power-good (PG) functions respectively. These devices are capable of supplying 1.5 A of output current with a dropout of 160 mV (TPS75133Q, TPS75333Q). Quiescent current is 75 µA at full load and drops down to 1 µA when the device is disabled. These devices are designed to have fast transient response for larger load current changes.

Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 160 mV at an output current of 1.5 A for the TPS75x33Q) and is directly proportional to the output current. Additionally, because the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 75 µA over the full range of output current, 1 mA to 1.5 A). These two key specifications yield a significant improvement in operating life for battery-powered systems.

The device is enabled when EN is connected to a low-level input voltage. This LDO family also features a sleep mode; applying a TTL high signal to EN (enable) shuts down the regulator, reducing the quiescent current to less than 1 µA at T_J = +25°C.

For the TPS751xxQ, the power-good terminal (PG) is an active high, open drain output for use with a power-on reset or a low-battery indicator.

The RESET (SVS, POR, or power on reset) output of the TPS753xxQ initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS753xxQ monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage. When the output reaches 95% of its regulated voltage, RESET goes to a high-impedance state after a 100-ms delay. RESET goes to a logic-low state when the regulated output voltage is pulled below 95% (that is, during an overload condition) of its regulated voltage.

The TPS751xxQ and TPS753xxQ are offered in 1.5 V, 1.8 V, 2.5 V and 3.3 V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges. The TPS751xxQ and TPS753xxQ families are available in a 20-pin TSSOP (PWP) package.

• 1.5-A Low-Dropout Voltage Regulator
• Available in 1.5 V, 1.8 V, 2.5 V, and 3.3 V Fixed Output and Adjustable Versions
• Open Drain Power-Good (PG) Status Output (TPS751xxQ)
• Open Drain Power-On Reset With 100ms Delay (TPS753xxQ)
• Dropout Voltage Typically 160 mV at 1.5 A (TPS75133Q)
• Ultralow 75-μA Typical Quiescent Current
• Fast Transient Response
• 2% Tolerance Over Specified Conditions for Fixed-Output Versions
• 20-Pin TSSOP PowerPAD? (PWP) Package
• Thermal Shutdown Protection
• APPLICATIONS
  • Telecom
  • Servers
  • DSP, FPGA Supplies

PowerPAD is a trademark of Texas Instruments. All other trademarks are the property of their respective owners.

• Output options
• Adjustable Output, Fixed Output
• Iout (Max) (A)
• 1.5
• Vin (Max) (V)
• 5.5
• Vin (Min) (V)
• 2.7
• Vout (Max) (V)
• 5
• Vout (Min) (V)
• 1.5
• Fixed output options (V)
• 1.5, 1.8, 2.5, 3.3
• Noise (uVrms)
• 60
• Iq (Typ) (mA)
• 0.075
• Thermal resistance θJA (°C/W)
• 43
• Rating
• Catalog
• Load capacitance (Min) (μF)
• 47
• Regulated outputs (#)
• 1
• Features
• Enable, Power good
• Accuracy (%)
• 2
• PSRR @ 100 KHz (dB)
• 17
• Dropout voltage (Vdo) (Typ) (mV)
• 160
• Operating temperature range (C)
• -40 to 125

TPS751的完整型号有：TPS75101QPWP、TPS75101QPWPR、TPS75115QPWP、TPS75115QPWPR、TPS75118QPWP、TPS75118QPWPR、TPS75125QPWP、TPS75125QPWPR、TPS75133QPWP、TPS75133QPWPR，以下是这些产品的关键参数及官网采购报价：

TPS75101QPWP，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：70个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75101QPWP的批量USD价格：2.64（1000+）

TPS75101QPWPR，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75101QPWPR的批量USD价格：2.2（1000+）

TPS75115QPWP，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：70个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75115QPWP的批量USD价格：2.64（1000+）

TPS75115QPWPR，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75115QPWPR的批量USD价格：2.2（1000+）

TPS75118QPWP，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：70个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75118QPWP的批量USD价格：2.64（1000+）

TPS75118QPWPR，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75118QPWPR的批量USD价格：2.2（1000+）

TPS75125QPWP，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：70个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75125QPWP的批量USD价格：2.64（1000+）

TPS75125QPWPR，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75125QPWPR的批量USD价格：2.2（1000+）

TPS75133QPWP，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：70个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75133QPWP的批量USD价格：2.64（1000+）

TPS75133QPWPR，工作温度：-40 to 125，封装：HTSSOP (PWP)-20，包装数量MPQ：2000个，MSL 等级/回流焊峰值温度：Level-2-260C-1 YEAR，引脚镀层/焊球材料：NIPDAU，TI官网TPS75133QPWPR的批量USD价格：2.2（1000+）

TIDM-LPBP-SENSORHUB — 具有七个板载传感器的综合传感器集线器解决方案

此传感器集线器设计使用 Tiva 平台评估传感器融合应用中基于 ARM Cortex-M4 的 TM4C 器件的使用情况，展示了 M4 架构的数学和算法计算特性。此设计具有七项板载传感器功能，包括 InvenSense MPU-9150 9 轴 MEMS 运动跟踪（3 轴陀螺仪、加速计和罗盘）、Bosch Sensortec BMP180 压力传感器、Sensirion SHT21 湿度和环境温度传感器、Intersil ISL29023 环境光线和红外线传感器以及 TI 的 TMP006 非接触式红外温度传感器。