- 制造厂商:TI
- 产品类别:电源管理
- 技术类目:线性和低压降 (LDO) 稳压器
- 功能描述:快速瞬态响应稳压器(增强型产品)
- 点击这里打开及下载TPS75218-EP的技术文档资料
- TI代理渠道,提供当日发货、严格的质量标准,满足您的目标价格
The TPS752xx and TPS754xx are low dropout regulators with integrated power-on reset and power good (PG) functions respectively. These devices are capable of supplying 2 A of output current with a dropout of 210 mV (TPS75233, TPS75433). Quiescent current is 75 µA at full load and drops down to 1 µA when the device is disabled. TPS752xx and TPS754xx are designed to have fast transient response for larger load current changes.
Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 210 mV at an output current of 2 A for the TPS75x33) and is directly proportional to the output current. Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 75 µA over the full range of output current, 1 mA to 2 A). These two key specifications yield a significant improvement in operating life for battery-powered systems.
The device is enabled when the EN\ pin is connected to a low-level input voltage. This LDO family also features a sleep mode; applying a TTL high signal to EN\ (enable) shuts down the regulator, reducing the quiescent current to 1 µA at TJ = 25°C.
The RESET\ (SVS, POR, or power on reset) output of the TPS752xx initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS752xx monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage. When the output reaches 95% of its regulated voltage, RESET\ goes to a high-impedance state after a 100-ms delay. RESET\ goes to a logic-low state when the regulated output voltage is pulled below 95% (i.e., over load condition) of its regulated voltage.
The TPS754xx has a power good terminal (PG) as an active high, open drain output, which can be used to implement a power-on reset or a low-battery indicator.
The TPS752xx or the TPS754xx are offered in 1.5-V, 1.8-V, 2.5-V, and 3.3-V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges. The TPS752xx and the TPS754xx families are available in 20 pin TSSOP (PWP) packages.
- Controlled Baseline
- One Assembly/Test Site, One Fabrication Site
- Enhanced Diminishing Manufacturing Sources (DMS) Support
- Enhanced Product-Change Notification
- Qualification Pedigree
- 2-A Low-Dropout Voltage Regulator
- Available in 1.5-V, 1.8-V, 2.5-V, 3.3-V Fixed Output and Adjustable Versions
- Open Drain Power-On Reset With 100-ms Delay (TPS752xx)
- Open Drain Power-Good (PG) Status Output (TPS754xx)
- Dropout Voltage Typically 210 mV at 2 A (TPS75233)
- Ultralow 75-μA Typical Quiescent Current
- Fast Transient Response
- 2% Tolerance Over Specified Conditions for Fixed-Output Versions
- 20-Pin TSSOP (PWP) PowerPAD? Package
- Thermal Shutdown Protection
PowerPAD is a trademark of Texas Instruments. Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over the specified temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life. Such qualification testing should not be viewed as justifying use of this component beyond specified performance and environmental limits.
- Output options
- Fixed Output
- Iout (Max) (A)
- 2
- Vin (Max) (V)
- 5.5
- Vin (Min) (V)
- 2.7
- Vout (Max) (V)
- 1.8
- Vout (Min) (V)
- 1.8
- Fixed output options (V)
- 1.8
- Noise (uVrms)
- 60
- Iq (Typ) (mA)
- 0.07
- Thermal resistance θJA (°C/W)
- 57.9
- Rating
- HiRel Enhanced Product
- Load capacitance (Min) (μF)
- 47
- Regulated outputs (#)
- 1
- Features
- Enable, Power good
- Accuracy (%)
- 2
- PSRR @ 100 KHz (dB)
- 16
- Dropout voltage (Vdo) (Typ) (mV)
- 210
- Operating temperature range (C)
- -40 to 125
TPS75218-EP的完整型号有:TPS75218QPWPREP、V62/03635-03XE,以下是这些产品的关键参数及官网采购报价:
TPS75218QPWPREP,工作温度:-40 to 125,封装:HTSSOP (PWP)-20,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-2-260C-1 YEAR,引脚镀层/焊球材料:NIPDAU,TI官网TPS75218QPWPREP的批量USD价格:4.409(1000+)
V62/03635-03XE,工作温度:-40 to 125,封装:HTSSOP (PWP)-20,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-2-260C-1 YEAR,引脚镀层/焊球材料:NIPDAU,TI官网V62/03635-03XE的批量USD价格:4.409(1000+)
TPS75218QPWPREP,工作温度:-40 to 125,封装:HTSSOP (PWP)-20,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-2-260C-1 YEAR,引脚镀层/焊球材料:NIPDAU,TI官网TPS75218QPWPREP的批量USD价格:4.409(1000+)
V62/03635-03XE,工作温度:-40 to 125,封装:HTSSOP (PWP)-20,包装数量MPQ:2000个,MSL 等级/回流焊峰值温度:Level-2-260C-1 YEAR,引脚镀层/焊球材料:NIPDAU,TI官网V62/03635-03XE的批量USD价格:4.409(1000+)