- 制造厂商:TI
- 产品类别:电源管理
- 技术类目:线性和低压降 (LDO) 稳压器
- 功能描述:具有使能功能的 150mA、10V、低 IQ、低压降稳压器
- 点击这里打开及下载TPS788的技术文档资料
- TI代理渠道,提供当日发货、严格的质量标准,满足您的目标价格
The TPS78825 and TPS78833 are very small (SOT-23) package, low-noise LDOs that regulate the output voltage to 2.5 V and 3.3 V with input voltage ranging from 2.7 V to an absolute maximum of 13.5 V. These devices output 150 mA with a peak current of 350 mA (typ). The TPS788xx family uses the SR pin to program the output voltage slew rate to control the in-rush current. This is specifically used in the USB application where large load capacitance is present at start-up. The TPS788xx devices use only 17 uA of quiescent current and exhibit only 56 uV RMS of output voltage noise using a 10 uF output capacitor.
The usual PNP pass transistor has been replaced by a PMOS pass element. Because the PMOS pass element behaves as a low-value resistor, the dropout voltage is very low, typically 150 mV at 150 mA of load current, and is directly proportional to the load current.
The TPS788xx also features a logic-enabled sleep mode to shut down the regulator, reducing quiescent current to 1 uA typical at TJ = 25°C.
- 150-mA Low-Dropout Regulator
- Available in 2.5 V, 3.3 V
- Programmable Slew Rate Control
- Output Noise Typically 56 uV RMS
- Only 17 uA Quiescent Current at 150 mA
- 1 uA Quiescent Current in Standby Mode
- Dropout Voltage Typically 150 mV at 150 mA (TPS78833)
- Over Current Limitation
- -40°C to 125°C Operating Junction Temperature Range
- 5-Pin SOT-23 (DBV) Package
- Output options
- Fixed Output
- Iout (Max) (A)
- 0.15
- Vin (Max) (V)
- 10
- Vin (Min) (V)
- 2.7
- Vout (Max) (V)
- 3.3
- Vout (Min) (V)
- 2.5
- Fixed output options (V)
- 2.5, 3.3
- Noise (uVrms)
- 56
- Iq (Typ) (mA)
- 0.017
- Thermal resistance θJA (°C/W)
- 180
- Rating
- Catalog
- Load capacitance (Min) (μF)
- 4.7
- Regulated outputs (#)
- 1
- Features
- Enable, Soft start
- Accuracy (%)
- 3
- PSRR @ 100 KHz (dB)
- 25
- Dropout voltage (Vdo) (Typ) (mV)
- 150
- Operating temperature range (C)
- 0 to 70
TPS788的完整型号有:TPS78825DBVR、TPS78825DBVT、TPS78833DBVR、TPS78833DBVT,以下是这些产品的关键参数及官网采购报价:
TPS78825DBVR,工作温度:0 to 70,封装:SOT-23 (DBV)-5,包装数量MPQ:3000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网TPS78825DBVR的批量USD价格:.46(1000+)
TPS78825DBVT,工作温度:0 to 70,封装:SOT-23 (DBV)-5,包装数量MPQ:250个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网TPS78825DBVT的批量USD价格:.552(1000+)
TPS78833DBVR,工作温度:0 to 70,封装:SOT-23 (DBV)-5,包装数量MPQ:3000个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网TPS78833DBVR的批量USD价格:.46(1000+)
TPS78833DBVT,工作温度:0 to 70,封装:SOT-23 (DBV)-5,包装数量MPQ:250个,MSL 等级/回流焊峰值温度:Level-1-260C-UNLIM,引脚镀层/焊球材料:NIPDAU,TI官网TPS78833DBVT的批量USD价格:.552(1000+)
DEM-SOT23LDO — 采用 5 条或 6 条引线 SOT23 (DBV) 封装与大多数正输出 LDO 稳压器兼容的 DEM-SOT23LDO
The purpose of this EVM is to facilitate evaluation of the TPS788xx family of LDO regulators. Each EVM contains an SLVP191 test board with a TPS78833DBV low dropout linear regulator as well as supporting passive components. Also, the board's small size and side clips facilitate attaching it to (...)