The UCC28065 interleaved PFC controller enables transition mode PFC at higher power ratings than previously possible. The device uses a Natural Interleaving™ technique to maintain a 180-degree phase shift. Both channels operate as masters (there is no slave channel) synchronized to the same frequency. This approach enables faster response time, accurate phase shift, and transition mode operation for each channel. The device has a burst mode function to get high light-load efficiency. Burst mode eliminates the need to turn off the PFC during light load operation to meet standby power targets, eliminating the need for an auxiliary Flyback when paired with UCC25640x LLC controller and the UCC24612 or UCC24624 synchronous rectifier controllers. The increased frequency clamping doubles the switching frequency capability compared with previous generation devices. The increased switching frequency range also allows the design to fully utilize the benefits of GaN MOSFETs such as LMG3410 and SiC MOSFETs.

Expanded system level protections features include input brownout and dropout recovery, output over-voltage, open-loop, overload, soft-start, phase-fail detection, and thermal shutdown. The additional fail-safe over-voltage protection (OVP) feature protects against shorts to an intermediate voltage that, if undetected, could lead to catastrophic device failure. Advanced non-linear gain results in rapid, yet smooth response to line and load transient events. Special line-dropout handling avoids significant current disruption. Strong reduction of bias current when not switching during burst mode operation, improves stand-by performance.

• Input filter and output capacitor ripple-current reduction
  • Reduced current ripple for higher system reliability and smaller bulk capacitor
  • Reduced EMI filter size
• Higher switching frequency support
  • Up-to 800-kHz switching frequency, reducing boost inductor size to at least one-half in size
  • Improved input-current THD
• High light-load efficiency
  • User adjustable phase management with input voltage compensation
  • Burst mode operation with adjustable burst threshold
  • Helps enable compliance to EUP Lot6 tier II, CoC tier II and DOE Level VI standards
• Sensorless current-shaping simplifies board layout and improves efficiency
• Input line feed-forward for fast line transient response
• Inrush-safe current limiting:
  • Prevents MOSFET conduction during inrush
  • Eliminates CCM operation and reverse recovery events in output rectifier

• Topology
• Boost
• Control mode
• TM
• Practical operating frequency (Max) (MHz)
• 0.8
• UVLO thresholds on/off (V)
• 10.35/9.6
• Device type
• Controllers
• Operating supply current (mA)
• 5
• Features
• 750W Applications, Audible Noise Minimization, Brown Out, Burst mode , Enable, Feed-forward Correction, Interleaved, Leading Edge Blanking, OVP, Soft Start, Peak Current Mode, Transition Control Mode
• Rating
• Catalog
• Operating temperature range (C)
• -40 to 125

UCC28065的完整型号有：UCC28065DR、UCC28065DT，以下是这些产品的关键参数及官网采购报价：

UCC28065DR，工作温度：-40 to 125，封装：SOIC (D)-16，包装数量MPQ：2500个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网UCC28065DR的批量USD价格：0.99（1000+）

UCC28065DT，工作温度：-40 to 125，封装：SOIC (D)-16，包装数量MPQ：250个，MSL 等级/回流焊峰值温度：Level-1-260C-UNLIM，引脚镀层/焊球材料：NIPDAU，TI官网UCC28065DT的批量USD价格：1.188（1000+）

UCC28064EVM-004 — 300W 交错 PFC 前置稳压器评估模块

该前置稳压器使用 UCC28064 转换模式交错式 PFC 控制器使输入电流波成形，以提供功率因数校正功能。此器件可提供高功率级别下的交错双相运行、较低功率级别下的单相运行以及极低功率级别下的突发模式运行。用户指南提供了典型应用的原理图、BOM、电气规格以及测试结果。